×
Menu

Wired Controllers (Xbox One, Xbox 360 and PS3) - Connecting to PS3

Using a Crossover Controller

 
Using a Crossover Controller
 
1
Set Output Protocol
 
 
Follow the instructions here to correctly connect your CronusMAX PLUS to a PC via the PC PROG port using the supplied Mini-USB Cable.
 
Load Cronus PRO and go to Tools > Options > Device
 
 
Set the Output Protocol to PS3.
 
These are also the recommended default Speed Up Settings for Wired Controllers.
 
You can now close the Options window and disconnect your CronusMAX PLUS from the PC. Rumble Over Bluetooth is disabled as it's not being used.
 
2
Connect the CronusMAX PLUS to your PS3
 
 
Connect the CronusMAX PLUS into one of your PlayStation 3 USB ports via it's Output Port.
 
 
  
The CronusMAX PLUS LED Display will now show the spinning Standby animation.
 
3
Connect your Crossover Controller to the CronusMAX
 
 
Connect your Wired Controller into the Input Port of the CronusMAX PLUS. If it's an Xbox One or DualShock 4 Wireless Controller use a full data Micro-USB Cable.
 
4
Ready to Use
 
  
After a couple of seconds the display on the CronusMAX LED will go from the spinning Standby Animation to 0 (or a number if slot recall is enabled and a script was previously loaded) - indicating that the controllers are authorized and you're ready to play. At this point you can use your controller through the CronusMAX PLUS and also load any scripts or GamePacks. It's that simple!
 
WARNING
If you are using an Xbox One or DualShock 4 Controller with a Micro USB cable and the LED on the CronusMAX PLUS changes back to AU then the Micro USB Cable is probably faulty or not compatible. Try another and make sure it is full data and not just a charging cable.