Results 1 to 1 of 1

Topic: DIY Adapter for Logitech/Thrustmaster

  1. #1
    Zen Beta Tester

    User Info Menu

    Question DIY Adapter for Logitech/Thrustmaster

    So you want to use the TM pedals with the G29. I'm going to approach this from a different angle but end up in the same place. My first 2 TM wheels on came with as 2 pedal set, so I made and adapter to use the G27/G29 pedals with the TM wheels. TM use an odd ball rj12 jack, the retention tag is offset.

    so I lopped off about 15 centimeters of the TM pedal lead. I then soldered a D-sub 9 female to the piece of the lead with the RJ12, hey presto the G27 pedals connect to the T150... You even get all 3 pedals....

    Attachment 5341

    the consequence of this is my TM pedals now had a wire with no connector... So I soldered on a male d-sub 9 to mate with the photo above essentially fixing the cut, the other consequence is that my TM pedals were now basically g27/g29 ready...

    the wire color might vary, I only ever made on adapter
    1 - gnd - red
    2 - gas - yellow
    3 - brake - blue
    4 - clutch - green
    5 -
    6 - presence - white
    7 -
    8 -
    9 - power - brown ( 3.3V )

    for reference here is some mouser links to the connectors:

    https://www.mouser.ie/ProductDetail/...JK1tjFl1%2fhvs

    https://www.mouser.ie/ProductDetail/...YRJIqQ4kYok1mM

    so if you want to swap gas and clutch you can simply swap the green and yellow wire
    Attached Images Attached Images

  2. The Following User Says Thank You to Podger For This Useful Post:


Posting Permissions

  • You may not post new topics
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •